Preset Module Reference

In order to select which modules to load when selecting a preset, you need to know which settings are contained in each module. Please refer to the references below.

EQ: All settings for EQ bands (freq uency, gain, Q, filter type) as well as EQ bypass settings, number of enabled EQ bands, Alt-Solo Q, and Soft Saturation option (on/off)

Reverb: All settings for the reverb including cutoff frequencies and Bypass On/Off

Maximizer: All settings for the loudness maximizer (but not the dither - this is controlled by the dither checkbox)

Exciter: All settings for the multiband exciter

Dynamics: All settings for the multiband dynamics module (but not the crossover points or number of bands - this is controlled by the crossovers checkbox)

Crossovers: Number of multibands (1, 2, 3 or 4) and crossover points for each band.

Imaging: All settings for the multiband stereo imaging module, including Channel Operations (mono, switch left/right, invert). Note that crossover points and number of bands are controlled by the crossovers checkbox.

Meters: All meter settings, including the spectrum, phase meters, level meters, etc.

Dither: All dither settings and DC offset filter on/off.

Levels: Controls whether group input and output gain (left and right linked) is on or off. Note that the input and output gain settings themselves are stored in the Global module. This was done to place all of the "program material" specific settings in the Global module.

Global: Input and Output level settings, including the "Gain when Bypassed" settings. Also includes the mute state for the multibands and the "Analog modeling always active" checkbox.