The Meters tab lets you control many of Ozone's meters.
|
Dynamics |
|
|
Enable histogram |
Turns on or off the level histogram meter. |
|
Gain reduction meter |
Turns on or off the gain reduction meter. |
|
Show peak hold |
Turns on or off the peak hold for the gain reduction meter. |
|
Peak hold time |
Allows you to set the peak hold time for the peaks of the gain reduction meter. |
|
Source |
Sets the source for the gain reduction meter. "Comp" displays the amount that the compressor and/or limiter is reducing for that band. "Gate" sets the readout to be the amount the expander/gate section is reducing for that band. Note that this meter only shows gain reduction. If you have the expander set to "upward compress" the level with a ratio less than one this meter will not show the amount that the signal is amplified. |
|
Curve level meter |
Allows you to turn on or off the dynamics curve level meter. |
|
Phase Meter |
|
|
Enable correlation meter |
Turns on or off the correlation meter. |
|
Show correlation meter history |
Turns on or off the history which the correlation meter "paints" as it updates. |
|
Enable vectorscope |
Turns on or off the vectorscope meter.
|
|
Show vectorscope history |
Turns on or off the history which the vectorscope "paints" as it updates. |
|
Normalize vectorscope |
When enabled, the vectorscope automatically applies gain to its input in order to make it fill the entire display. When disabled, quieter signals will appear smaller on the vectorscope display. |
|
Maximizer |
|
|
Enable histogram |
Turns on or off the level histogram meter. |
|
Gain reduction meter |
Turns on or off the gain reduction meter. |
|
Show peak hold |
Turns on or off the peak hold for the gain reduction meter. |
|
Peak hold time |
Allows you to set the peak hold time for the peaks of the gain reduction meter. |
|
Dithering |
|
|
Enable DC offset meter |
Turns on or off the DC offset meter. |
|
Enable bit meter |
Turns on or off the bit meter. |
|
Show peak hold |
Turns on or off the peak hold for the bit meter, meaning the outer column of bits that remain lit when that bit is toggled. |
|
Peak hold time |
Allows you to set a time for the bits to be held before they are reset and recalculated from the real time bit meter columns. |